Section 12-02: Heating and Defrosting
1993 Mustang Workshop Manual
REMOVAL AND INSTALLATION

Temperature Control Cable

 

Removal

  1. Remove control assembly from instrument panel.
  1. Disengage temperature control cable from cable actuator on control assembly.
  1. Disconnect temperature cable from plenum temperature blend door crank arm and cable mounting bracket.
  1. Note cable routing and remove cable from vehicle.
 

Installation

  1. Check to ensure self-adjusting clip is at least 25.4mm (1 inch) from end loop of control cable. Refer to Adjustments.
  1. Route cable behind instrument panel and connect control cable to mounting bracket on plenum.
  1. Install self-adjusting clip on temperature blend door crank arm.
  1. Engage cable end with cable actuator on control assembly.
  1. Install control assembly in instrument panel.
  1. Turn TEMP control knob all the way to the right (WARM) to position self-adjusting clip on control cable.
  1. Check temperature control knob for proper operation.
  1. Check system for proper operation.