NOTE: Do not remove the anchor plate unless it is being replaced.
Perform the Caliper Assembly Removal procedure. If service is not necessary
to the caliper assembly, it is not necessary to disconnect the flexible hose
from the caliper in this operation. Support the caliper with a wire hook or
other means, so that the flexible hose is not stretched or twisted.
Remove and discard both the upper and lower anchor plate-to-axle adapter
mounting bolts. Remove the anchor plate.
Installation
Clean all foreign material and locking compound residue from the mating
surfaces of the axle adapter and anchor plate.
Position the anchor plate on the axle adapter. Install new upper and lower
mounting bolts finger-tight.
Tighten both bolts to 108-149 Nm (80-110 lb-ft).
Install the caliper assembly. Refer to Caliper Assembly, Installation.