Rotor

Removal

1. Remove the parking brake cable clip and cable.

   Support the caliper and anchor plate assembly with a wire hook or other means, so that the flexible hose is not stretched or twisted.

2. Remove the two bolts that attach the anchor plate to the brake adapter.

3. Remove the two retainer nuts. Remove the rotor from the axle shaft.

Installation

1. If rotor is being replaced, remove protective coating from new rotor with Carburetor Tune-Up Cleaner D9AZ-19579-AA (ESR-M14P9-A).

2. Install the rotors on the axle shaft flange. Install the two retainer nuts securely.

3. Clean the adapter plate and attaching bolt threads. Add one drop of Threadlock and Sealer meeting specification E0AZ-19554-A (ESE-M4G204-A) or equivalent to each bolt and attach the caliper anchor assembly to the adapter. Tighten the bolts to 87-119 Nm (64-88 lb-ft).

4. Mount the caliper assembly on the anchor plate slides. Refer to Caliper Assembly , Installation.