Section 12-03A: Air Conditioning System—Manual A/C-Heater
1994 Mustang Workshop Manual
REMOVAL AND INSTALLATION

Switch Knobs

 

Removal and Installation

  1. To remove any of the three control knobs (18519) on the air conditioner control (19980) , grasp and pull rearward.

    NOTE: Do not pry the knob off its shaft as damage to the surface of the air conditioner control assembly bezel may result.

  1. If the D-shaped spring clip which sits inside back end of knob remains on shaft when knob is pulled off, remove it with needlenose pliers and install in knob .
  1. To install knob , align its keyed surface with mating surface on shaft. Press knob forward until fully seated in air conditioner control .
 

Blower Motor Switch

Removal and Installation

  1. Remove air conditioner control as outlined.
  1. Remove knob.
  1. Disconnect electrical connector.
  1. Remove retaining screw.
  1. Remove blower motor switch (19986) .
  1. To install, reverse Removal procedure.
 

A/C Damper Door Switch

Removal and Installation

  1. Remove air conditioner control as outlined.
  1. Remove knob.
  1. Disconnect vacuum bundle and electrical connector.
  1. Remove retaining screw.
  1. Remove A/C damper door switch (19B888).
  1. To install, reverse Removal procedure.