Crankshaft Position Sensor

Removal

1. Disconnect battery ground cable (14301) .

2. Raise vehicle and suitably support. Refer to Section 00-02.

3. Disconnect engine control sensor wiring connector from crankshaft position sensor (CKP sensor) (6C315) .

4. Remove crankshaft position sensor shield.

5. Remove crankshaft position sensor retaining bolts and crankshaft position sensor .

Installation

1. Position crankshaft position sensor on engine front cover (6019) .

2. Install two crankshaft position sensor retaining stud bolts. Tighten to 4.5-7.0 Nm (40-61 lb-in).

3. Install crankshaft position sensor shield. Tighten retaining nut to 2-4 Nm (18-35 lb-in).

4. Route crankshaft position sensor wiring harness and connect engine control sensor wiring connector.

5. Lower vehicle.

6. Connect battery ground cable .
   
   
   
   
   

   Item	Part Number	Description
   1	6019	Engine Front Cover
   2	6C315	Crankshaft Position Sensor
   3	6K342	Crankshaft Position Sensor Shield
   4A	M5 X 0.8	Nut (2 Req'd)
   5B	M5 X 0.8 X 0.8 X 39	Stud Bolt (2 Req'd)
   A		Tighten to 2-4 Nm (18-35 Lb-In)
   B		Tighten to 4.5-7.0 Nm (40-61 Lb-In)