Section 01-20B: Restraints, Passive—Supplemental Air Bag System
1994 Mustang Workshop Manual
DISPOSAL PROCEDURES

Air Bag Disposal

 WARNING: REMOTE DEPLOYMENT IS TO BE PERFORMED OUTDOORS WITH ALL PERSONNEL AT LEAST 20 FEET AWAY TO ENSURE PERSONAL SAFETY AND DUE TO THE LOUD REPORT WHICH OCCURS WHEN AN AIR BAG IS DEPLOYED.

  1. Remove the driver side air bag module (043B13) and passenger side air bag module (044A74) as outlined.
  1. Cut the two air bag connector wires and strip 25mm (1 inch) of insulation from the ends. Obtain two wires at least 6m (20 feet). Connect one end of each wire to each of the air bag module wires.
  1. Place the air bag with the trim cover facing upward on a flat surface in a remote area such as a parking lot or field.

     WARNING: DO NOT PLACE THE AIR BAG WITH THE TRIM COVER FACING DOWN, AS THE FORCES OF THE DEPLOYING AIR BAG MAY CAUSE IT TO RICOCHET AND CAUSE PERSONAL INJURY.

  1. Remaining at least 6m (20 feet) away from the air bag, deploy the air bag by touching the other ends of the two wires to the terminals of a 12-volt vehicle battery (10653).
  1. If successful, a loud report will be heard and the air bag material will be visible. Allow at least 10 minutes before approaching the air bags to allow for cooling.

    The air bags are now deployed and may be scrapped in accordance with scrap metal procedures.