Remove rear hi-mount lamp (13A613)
from luggage compartment door
.
To install, reverse Removal procedure. Tighten screws to 5.8-8.2 Nm
(45-72 lb-in).
Cobra
Removal
Disconnect rear hi-mount lamp wiring (13A625)
from the main luggage compartment wire harness.
Remove the four luggage compartment door outside center extension retaining
nuts, with socket wrench and socket.
Tilt luggage compartment door outside center extension (44210)
forward, so the rear portion of the foot is off the luggage compartment door
. Unseal wiring grommet by pushing from inside of luggage compartment door
.
Pull rear hi-mount lamp wiring
through and out of luggage compartment door
.
Lift the luggage compartment door outside center extension
off luggage compartment door
and place upside down on table.
Remove the two screws retaining cover with a Phillips screwdriver.
Remove cover, while pulling rear hi-mount lamp wiring
through luggage compartment door outside center extension
.
Remove the three screws holding rear hi-mount lamp
on cover.
Installation
Position rear hi-mount lamp
to luggage compartment door outside center extension
. Feed rear hi-mount lamp wiring
through tunnel in luggage compartment door outside center extension
, until excess slack is recovered at foot.
Install cover and tighten screws.
Place forward luggage compartment door outside center extension studs in
forward holes on luggage compartment door
.
Feed rear hi-mount lamp wiring
through hole, pull on rear hi-mount lamp wiring
in luggage compartment to seat grommet in hole.
Place rear luggage compartment door outside center extension studs in
rearward holes on luggage compartment door
.
Install and tighten retaining nuts.
Feed rear hi-mount lamp wiring
through inner and outer panels of luggage compartment door
. Connect into main luggage compartment wire assembly.
