Section 11-05: Steering Column Switches
1994 Mustang Workshop Manual
REMOVAL AND INSTALLATION

Ignition Switch

 

Removal

  1. Disconnect battery ground cable .
  1. Disconnect the ignition switch electrical connector.
  1. Rotate the ignition switch lock cylinder to the RUN position.
  1. Remove the two screws retaining ignition switch .
  1. Disengage the ignition switch from the actuator pin.
 

Installation

NOTE: A new replacement ignition switch assembly will be set in the RUN position as received.

  1. Adjust the ignition switch by sliding the carrier to the switch RUN position.
  1. Check to ensure that the ignition switch lock cylinder is in the RUN position. The RUN position is achieved by rotating the ignition switch lock cylinder approximately 90 degrees from the LOCK position.
  1. Install the ignition switch onto the actuator pin. It may be necessary to move the ignition switch slightly back and forth to align the ignition switch mounting holes with the lock cylinder housing threaded holes.
  1. Install retaining screws. TIghten to 5.6-7.9 Nm (50-69 lb-in).
  1. Connect the electrical connector to the ignition switch .
  1. Connect battery ground cable . Check ignition switch for proper function, including START and ACC positions. Also, make certain that the column is locked in the LOCK position.