Turn Signal and Windshield Wiper Switch

Removal

1. Disconnect battery ground cable (14301) .

2. Remove steering column shroud retaining screws and remove upper and lower steering column shrouds . Refer to Section 11-04.

3. Remove wiring connectors.

4. Remove two self-tapping screws retaining turn signal and windshield wiper switch to steering column casting. Disengage switch from casting.

Installation

1. Align turn signal and windshield wiper switch mounting holes with corresponding holes in the steering column casting. Install two self-tapping screws making sure to start the screws in the previously tapped holes. Tighten 2-3 Nm (18-26 lb-in).
   
   
   
   

2. Install electrical connector to full engagement.

3. Install upper and lower steering column shrouds with the screws. Tighten to 0.6-1.13 Nm (6-10 lb-in).

4. Connect battery ground cable .

5. Check steering column tube and turn signal and windshield wiper switch for proper operation.