Wiper Control Switch

Intermittent

The wiper switch is located in the knob at the end of the turn signal lever.

• To operate the wiper, the ignition switch must be in the RUN position.
• In addition to "O" (OFF), there are two fixed speed wiper positions (LO, (low), HI, (high) and an interval position.
• The positions are selected by rotating the knob actuator relative to the turn signal lever.
• If interval is selected, the time between wiper cycles will decrease as the knob is rotated away from OFF position.
• The time interval will increase as the knob is rotated toward OFF position.
• The time interval between wipes will vary depending on the knob's position from OFF position.