If dirt is found in the power steering gear (3504)
, flush the power steering pump (3A674)
as follows:
Make sure all other hoses are connected, then disconnect the power steering pressure hose (3A719)
at the steering gear
.
Place the power steering pressure hose
in a container.
Fill the power steering oil reservoir (3A697)
with Premium Power Steering Fluid E6AZ-19582-AA or
equivalent meeting Ford specification ESW-M2C33-F.
Disconnect the ignition coil wire.
While adding approximately 1.9 liters (0.5 gallon) of fluid, turn ignition switch (11572)
to the ON position, and crank the engine with the
starter. As soon as all fluid has been added, turn the ignition switch
to the OFF position.
Connect the power steering pressure hose
at the steering gear
.
Check the fluid level.
Crank the engine with the starter and add fluid until the level remains
constant.
Lower the vehicle and connect the ignition coil wire.
Start the engine and turn the steering wheel (3600)
from lock-to-lock to expel any air trapped in the
system. This will restore normal steering action.