Brake Sensors

Front

Removal

1. Raise vehicle on hoist. Refer to Section 00-02.

2. Remove the front wheel and tire assembly.

3. Remove the anti-lock brake sensor bolt and pull the front brake anti-lock sensor (2C204) from the front wheel spindle (3105) .

4. Remove the two anti-lock brake cable bracket bolts and the two wheel anti-lock brake sensor cable brackets.

5. Remove the two anti-lock brake sensor cable bracket-to-wheel well screws.

6. Push the anti-lock brake sensor cable grommet through the wheel well.

7. Disconnect the anti-lock brake sensor electrical connector in the engine compartment and pull the harness retainer from the vehicle.

8. Remove the front brake anti-lock sensor from the vehicle.

Installation

1. Position the front brake anti-lock sensor in the vehicle. Attach it with the harness retainer in the engine compartment.

2. Connect the anti-lock brake sensor electrical connector.

3. Install the anti-lock brake sensor cable grommet in the wheel well.

4. Position the anti-lock brake sensor cable on the wheel well and install the two sensor cable bracket-to-wheel well screws.

5. Position the two sensor cable brackets on the strut. Install the two sensor cable bracket bolts.

6. Position the front brake anti-lock sensor on the front wheel spindle and install the bolt. Tighten the bolt to 11-15 Nm (124-133 lb-in).

7. Install the front wheel and tire assembly. Tighten the wheel hub bolt nuts (1012) to 98-118 Nm (78-87 lb-ft).

8. Lower the vehicle.

Rear

Removal

1. Raise vehicle on hoist. Refer to Section 00-02.

2. Remove the rear brake anti-lock sensor bolt.
   
   
   
   

3. Remove the rear brake anti-lock sensor (2C190) .

Installation

1. Position the rear brake anti-lock sensor on the vehicle.

2. Install rear brake anti-lock sensor and tighten to 4.5-6.8 Nm (40-60 lb-in).