Section 03-14: Engine Controls, Electronic
1994 Mustang Workshop Manual
REMOVAL AND INSTALLATION

Idle Air Control (IAC) Valve

 

Removal

  1. Disconnect battery ground cable (14301) .
  1. Disconnect the idle air control valve (IAC valve) (9F715) from the fuel charging wiring (9D930) .
  1. Remove the two idle air control valve retaining screws.
  1. Remove the idle air control valve and idle air control valve gasket.
 

Installation

NOTE: If scraping is necessary, be careful not to damage idle air control valve or throttle body idle air control valve gasket surfaces, or drop gasket material into throttle body (9E926) .

  1. Clean idle air control valve gasket mating surfaces.
  1. To install idle air control valve, reverse Removal procedure. Tighten retaining screws to 9.5 Nm (7 lb-ft).