Section 03-07A: Ignition, Distributor
1994 Mustang Workshop Manual
REMOVAL AND INSTALLATION

Ignition Control Module

 

Removal

  1. Disconnect engine control sensor wiring (12A581) connector from ignition control module (ICM) (12A297) .
  1. Remove screws retaining heatsink/ ignition control module to front fender apron (16055) .
  1. Remove two screws retaining ignition control module to heatsink and remove ignition control module .
 

Installation

  1. Coat metal baseplate of ignition control module uniformly with silicone compound, approximately 0.79mm (1/32 inch) thick. Use Silicone Dielectric Compound D7AZ-19A331-A (in Canada, Motorcraft WA-10) meeting Ford specification ESE-M1C171-A.
  1. Position ignition control module onto heatsink and tighten two retaining screws to 1.7-4.0 Nm (15-35 lb-in).
  1. Install ignition control module heatsink assembly to RH front fender apron . Tighten retaining screws securely.
  1. Connect engine control sensor wiring to the ignition control module .