Section 03-07A: Ignition, Distributor
1994 Mustang Workshop Manual
REMOVAL AND INSTALLATION

Distributor Cap

 

Removal

  1. Loosen distributor cap hold-down screws.
  1. Remove distributor cap (12106) straight off distributor (12127) to prevent damage to distributor rotor blade and spring.
 

Installation

  1. Position distributor cap on distributor base noting the square alignment locator. Tighten hold-down screws to 2.0-2.6 Nm (18-23 lb-in).
  1. Install any ignition wires that were removed, noting their correct locations on the distributor cap .


4-Cylinder Engine Shown, 8-Cylinder Engine Similar