Crankshaft Rear Oil Seal

A one-piece crankshaft rear oil seal (6701) is used on this engine.

SPECIAL SERVICE TOOL(S) REQUIRED

Description	Tool Number
Jet Plug Remover	T77L-9533-B
Rear Main Seal Installer	T82L-6701-A

Removal

 CAUTION: Avoid scratching or damaging oil seal surface.

1. Remove transaxle as outlined. Refer to applicable Section in Group 07.

2. Using a sharp awl, punch one hole into the crankshaft rear oil seal metal surface between lip and cylinder block (6010) .

3. Screw in the threaded end of Jet Plug Remover T77L-9533-B. Use the jet plug remover to remove crankshaft rear oil seal .

Installation

1. Position crankshaft rear oil seal on Rear Main Seal Installer T82L-6701-A. Position tool and crankshaft rear oil seal to rear of cylinder block .

2. Alternate bolt tightening to seat crankshaft rear oil seal properly. (Two bolts are supplied with Rear Main Seal Installer T82L-6701-A. Engine flywheel bolts may be used if necessary.)
   
   
   
   

3. Install transaxle as outlined. Refer to applicable Section in Group 07.