Windshield Washer System

The windshield washer system:

• Uses two windshield washer nozzle jet and brackets (17603) located on the cowl top panel (02010) .
• Is activated by pushing inward on the rotary wiper switch.
• Has a windshield washer pump (17664) mounted inside a cavity in the windshield washer reservoir (17618) .
• Has a windshield washer reservoir mounted on the LH front fender apron (16054) .

If turn signal and windshield wiper switch (13K359) is in OFF or Interval position:

• Wipers will run as long as the rotary wiper switch is pushed in.
• When released, washers will stop immediately.
• Wipers will continue to run for three to four cycles before returning to OFF or Interval operation.

If turn signal and windshield wiper switch is in LO or HI position:

• Washers operate with no change in wiper operation.

The windshield washer nozzle jet and bracket expels what appears to be a wide fan-like spray pattern of large droplets of fluid on the windshield glass (03100) .

• It is actually a single oscillating jet stream.
• Care should be taken to actuate the system only momentarily because of the greater volume of fluid that is dispersed with this system.