Heated Back Window Switch and Light

Removal and Installation

1. Disconnect the battery ground cable (14301) .

2. Remove the instrument panel finish panel (044D70) . Refer to Section 01-12.

3. Disengage the locking tabs on the RH side of heated back window switch and light (18C621) by pushing the tabs in with a small screwdriver and pulling on the RH side of the heated back window switch and light .

4. Using a screwdriver, pry the LH side of the heated back window switch and light out of the instrument panel (04320) .

5. Pull the heated back window switch and light completely out of the opening and disconnect the connector.

6. To install, reverse Removal procedure. Make sure the locking tabs on both sides of the heated back window switch and light snap in place.