Window Regulator Electric Drive

Front Door

Removal

1. Raise the front door window glass (21410) to the full-up position, if possible. If the front door window glass cannot be raised and is in a partially down position, it must be supported so that it will not fall into the door well during window regulator electric drive removal.

2. Disconnect battery ground cable (14301) .

3. Remove front door trim panel (23942) and watershield. Refer to Section 01-05.

4. Disconnect front window regulator wiring connector.

    CAUTION: Prior to window regulator electric drive (23394) removal, ensure that the regulator arm is in a fixed position to prevent counterbalance spring unwind.

5. Remove the three window regulator electric drive mounting screws and disengage the window regulator electric drive assembly from the front door window regulator.

Installation

1. Install the window regulator electric drive . Tighten the retaining screws to 5.6-9.6 Nm (50-84 lb-in).

2. Connect the front window regulator wiring connector.

3. Connect battery ground cable . Check window regulator electric drive for proper operation.

4. Install the front door trim panel and watershield. Refer to Section 01-05.

5. Check the drain holes at the bottom of the front doors (20124) to make sure that each is open to prevent water buildup over the window regulator electric drive .