Section 01-11: Glass, Frames and Mechanisms
1994 Mustang Workshop Manual
REMOVAL AND INSTALLATION

Window Regulator

 

Front Door

Removal

  1. Remove front door glass as outlined.
  1. Remove front door trim panel (23942) and watershield. Refer to Section 01-05.
  1. Disconnect the front window regulator wiring (14631) if so equipped.
  1. Remove window regulator equalizer arm.
  1. Remove the four rivets attaching the regulator to the inner door panel. Remove the center pin from each rivet with a drift punch. Using a 1/4-inch drill, drill out the remainder of the rivet, using care not to enlarge the sheet metal retaining holes.

     WARNING: IF THE REGULATOR COUNTERBALANCE SPRING MUST BE REMOVED OR REPLACED FOR ANY REASON, ENSURE THAT THE REGULATOR ARMS ARE IN A FIXED POSITION PRIOR TO REMOVAL TO PREVENT POSSIBLE INJURY DURING C-SPRING UNWIND.

  1. Remove the regulator from the door access hole.
 

Installation

  1. Install window regulator through the access hole in the front door (20124) .

    NOTE: 1/4-20x1/2 inch screws and 1/4-20 nuts and washers may be substituted for the rivets. Tighten to 10.2-13.8 Nm (8-10 lb-ft).

  1. Position the regulator base plate to the inner door panel and install four rivets.
  1. Install front door window glass (21410) as outlined.
  1. Connect the front window regulator wiring , if equipped.
  1. Cycle the front door window glass to ensure proper operation.
  1. Install the front door trim panel and watershield. Refer to Section 01-05.

    Window Regulator, Front Door





    Item Part Number Description
    1 21572(RH)
    21573(LH)
    Door Glass Run Retainer, Front
    2 23200 RH
    23201 LH
    Power Window Regulator, Front Door
    3A N800251-S36 Nut and Washer (4 Req'd)
    4 223A72 RH
    223A73 LH
    Front Door Glass Hinge Side Run
    5 23230 Window Regulator Equalizer Arm Bracket
    6B N621906-S36 Nut and Washer (2 Req'd)
    7 W525172-S Rivet (4 Req'd)
    8 23200 RH
    23201 LH
    (Manual) Power Window Regulator, Front Door
    9 23370 Window Regulator Handle Plate
    10 23342 (Manual) Window Regulator Handle
    A Tighten to 10.7-13.3 Nm (8-9 Lb-Ft)
    B Tighten to 5.9-8.1 Nm (52-71 Lb-Ft)