Section 08-02: Clutch Controls
1994 Mustang Workshop Manual
REMOVAL AND INSTALLATION

Clutch Pedal Position Switch

 

Removal

  1. Disconnect wiring connector.
  1. Remove retaining pin from clutch pedal (7519) .
  1. Remove clutch pedal position switch retaining screw.
  1. Move clutch pedal position switch (CPP switch) (11A152) inward to disengage actuating rod eyelet from clutch pedal pin. Remove clutch pedal position switch from vehicle.
 

Installation

NOTE: Always install the clutch pedal position switch with the self-adjusting clip about 25.4mm (1 inch) from the end of the rod. The clutch pedal must be fully up (clutch engaged), otherwise the clutch pedal position switch may be misadjusted.

  1. Place eyelet end of rod onto pivot pin.
  1. Install retaining screw.
  1. Install retaining pin on clutch pedal .
  1. Connect wiring connector.