Output Shaft

1. Check output and fifth gear drive shaft (7061) for runout by mounting the output and fifth gear drive shaft between V-blocks and applying Dial Indicator with Bracketry TOOL-4201-C or equivalent to several places along output and fifth gear drive shaft . The standard reading of the indicator for runout should be less than 0.05mm (0.002 inch). If runout exceeds 0.05mm (0.002 inch), replace output and fifth gear drive shaft .

2. Replace output and fifth gear drive shaft if splines are damaged. If needle bearing surface on the bearing journal is damaged, replace the output and fifth gear drive shaft .