Section 07-01: Transmission, Automatic—AODE
1994 Mustang Workshop Manual
DISASSEMBLY AND ASSEMBLY OF SUBASSEMBLIES

Pump Bushing

SPECIAL SERVICE TOOL(S) REQUIRED
Description Tool Number
Bushing Remover T80L-77268-B
Bushing Installer T80L-77268-A

 

Disassembly

  1. If required, remove front oil pump bushing (7B258) using Bushing Remover T80L-77268-B.



 

Assembly

  1. To install, press the front oil pump bushing using Bushing Installer T80L-77268-A.



 

Assembly

  1. Install the front oil pump seal (7A248) using Front Pump Seal Replacer T63L-77837-A.



  1. Install new intermediate clutch piston inner seal (7F225) and intermediate clutch piston outer seal (7F224) on intermediate clutch piston (7E005).



     CAUTION: The piston bleed hole must be located at 12 o'clock position (toward top of transmission).

    NOTE: Piston bleed hole is the only round hole in the intermediate clutch piston assembly.

  1. Note location of the piston bleed hole.



    NOTE: Coat intermediate clutch piston outer seal and intermediate clutch piston inner seal and pump body sealing area with petroleum jelly.

  1. Install intermediate clutch piston as follows:
    1. Install intermediate clutch piston in Seal Protector T80L-77005-A.



  1. Install intermediate clutch piston in pump body and push intermediate clutch piston to the bottom of the bore by exerting even pressure.



  1. Snap spring retainer assembly into place on pump body.



  1. Install the inner and outer pump gears in pump body.

    The flats have steps that must face the pump body for ease of installing the torque converter (7902).



  1. Install reverse clutch cylinder seal (7D020) and forward clutch cylinder seals.



  1. Position front pump stator support to pump body and install retaining bolts. Tighten to 20-26 Nm (15-19 lb-ft).