Cable and Conduit, Rear

Removal

1. Place parking brake control (2780) in the release position and release cable tension as outlined under Adjustments.

2. Raise vehicle. Refer to Section 00-02.

3. Remove parking brake rear cable and conduit (2A635) from rear disc brake caliper (2552) .

4. Remove parking brake cable brackets (2530) from rear suspension lower arm (5A649) .

5. Remove parking brake rear cable and conduit from the parking brake cable and equalizer (2A603) .

6. Remove parking brake rear cable and conduit from brake hose clip (2860) .

7. Remove parking brake rear cable and conduit from vehicle.
   
   Parking Brake Control, Cable and Conduit
   
   
   
   
   
   

   Item	Part Number	Description
   1	2A635	Parking Brake Rear Cable and Conduit
   2	2780	Parking Brake Control
   3A	55914-S2	Bolt
   4B	N805162-S2	Bolt (2 Req'd)
   5	97413-S56	Clip (2 Req'd)
   6	2552	Rear Disc Brake Caliper
   7	2A603	Parking Brake Cable and Equalizer
   A		Tighten to 5-6 Nm (45-53 Lb-In)
   B		Tighten to 14-21 Nm (10-16 Lb-Ft)

Installation

1. Install rear parking brake rear cable and conduit in tunnel.

2. Attach parking brake rear cable and conduit to brake hose clip .

3. Attach parking brake rear cables and conduit ends to parking brake rear cable and conduit .

4. Attach parking brake cable brackets to rear suspension lower arm .

5. Route parking brake rear cable and conduits through parking brake cable bracket .

6. Attach parking brake rear cable and conduit to rear parking brake cable (2A637) on rear disc brake caliper .

7. Install retaining clips on rear disc brake calipers .