Brakes, Front Disc

The front disc brakes operate as follows:

• The brakes use pin slider-type front disc brake caliper (2B120) assemblies with a 276mm (10.9 inch) full cast front disc brake rotor (1125) .
• The front disc brake caliper has a steel wheel cylinder piston (2196) with a piston seal and a press-in type dust boot.
• The front disc brake caliper is attached to the front wheel spindle (3105) with two 12mm attaching bolts.
• The front disc brake caliper slides on lubricated disc brake caliper locating pins (2B296) that are sealed from the elements by rubber boots.
• The disc brake caliper locating pins are attached to the caliper housing by two pinch bolts.
• Vehicles are equipped with galvanized steel disc brake front disc brake rotor shields (2K005) .
• Front disc brake rotor shields are attached to the front wheel spindle with three pop-rivets per side and are not interchangeable side-to-side.
• The brake shoes and linings (2001) are fully interchangeable and slide into the caliper anchor bracket assembly.
• The brake shoes and linings use a single purpose clip which holds the brake shoes and linings against the anchor bracket to prevent brake shoe rattles.