Shoulder Harness, Rear

2 and 3 Door Models

Removal and Installation

NOTE: Rear seat must be unlatched at front edge and pulled forward to remove bolts retaining buckle ends. Refer to Section 01-10A.

1. Remove rear seat cushion.

2. Remove rear seat back. Refer to Section 01-10A.

3. On 2-door models, remove rear seat shoulder belt retractor cover by pushing front edge of cover upward and sliding forward in the vehicle. On 3-door models remove the rear quarter trim panel.

4. Remove retractor anchor nut.

5. Remove safety belt anchor to floorpan bolt.

6. Remove rear seat shoulder belt retractor cover and belt opening bezel. Retain for installation on replacement belt and retractor assembly.

7. Position replacement components as shown. Reverse Removal procedure. Tighten attachments to 30-40 Nm (23-29 lb-ft).

Convertible

Removal and Installation

NOTE: Rear seat must be unlatched at front edge and pulled forward to remove bolts attaching buckle ends. Refer to Section 01-10A.

1. Remove rear seat cushion.

2. Remove two screw attachments of the retractor webbing guide at the rear seat back.

3. Remove luggage compartment liner.

4. Remove retractor webbing and anchor bolt through the top sling from the luggage compartment.

5. Remove safety belt anchor to floorpan bolt.

6. Remove safety belt anchor end through the seat back boot.

7. Position replacement components as shown. Reverse Removal procedure. Tighten attachments to 30-40 Nm (23-29 lb-ft).