Section 01-17A: Convertible
1993 Mustang Workshop Manual
REMOVAL AND INSTALLATION

Panel and Regulator—Power

 

Removal

  1. Remove motor as outlined.
  1. Remove C-clip and disconnect quarter window lift arm from guide.



  1. Remove seven retaining screws and remove panel and regulator from vehicle.
  1. If regulator is to be removed from panel, place panel and regulator assembly on bench.
  1. Drill out regulator rear retaining rivet.



  1. Remove four retaining bolts and washers and remove regulator from panel.
  1. If desired, remove upper run retainer and glass stabilizer by removing retaining nut and washer.
 

Installation

  1. Attach upper run retainer and glass stabilizer to panel with nut and washer. Tighten nut to 6-7 Nm (54-62 lb-in).
  1. Install regulator to panel with four retaining bolts and washers. Tighten bolts to 8-15 Nm (6-11 lb-ft).
  1. Install new rear regulator retaining rivet and two washers.
  1. Install regulator and panel with seven retaining screws. Tighten screws to 8-15 Nm (6-11 lb-ft).
  1. Install lift arm, washers and C-clip on guide.
  1. Install motor.
  1. Install front shoulder belt retractor, quarter trim panel and rear seat back and cushion as outlined.