Motor Assembly—Power

Removal and Installation

1. Remove rear seat back and cushion, quarter trim panel and front shoulder belt retractor as outlined.

2. Disconnect motor-to-switch electrical connector.

3. Remove three motor assembly retaining bolts and washers and remove motor from regulator panel.
   
   
   
   

4. If desired, remove bracket and seal from motor by removing three bracket retaining screws and one seal retaining screw.
   
   
   
   

5. To install, reverse Removal procedure. Tighten motor assembly retaining bolts to 6-7 Nm (54-62 lb-in).