Section 01-10A: Seats and Tracks
1993 Mustang Workshop Manual
REMOVAL AND INSTALLATION

Folding Arm, Rear Seat

 

Removal

  1. Fold seat back down.
  1. Carefully pry up five push pins to disengage carpet from seat back.
  1. Remove three screws retaining arm to seat back.
  1. Remove two screws retaining arm to load floor extension.
  1. Remove outboard pivot bolt and remove arm and washer.
 

Installation

  1. Position arm and washer in vehicle and install outboard pivot bolt. Tighten to 16-27 Nm (12-20 lb-ft).
  1. Install two screws retaining folding arm to load floor extension. Tighten to 8-14 Nm (6-10 lb-ft).
  1. Install three screws retaining folding arm to seat back. Tighten to 4-5 Nm (35-44 lb-in).
  1. Position carpet on seat back and engage five push pins.
  1. Raise seat back to latched position. Adjust latch and striker as outlined, if necessary.