Flasher Units

Removal and Installation

The hazard flasher can be removed by pulling straight out. When installing a new flasher, line up the metal terminals with the slots in the fuse panel, then press the flasher firmly into place. The turn signal flasher is located on the instrument panel reinforcement flange above the fuse panel.

Hazard flasher unit is mounted on the rear side of the fuse panel.

Slot Mounted Flashers, Turn Signal

Removal and Installation

To remove this type of flasher, rotate the unit 90 degrees counterclockwise to disengage it from the mounting slot, and disconnect the wiring plug. To install, lock the flasher in place by inserting the tab in the slot and rotating 90 degrees clockwise. Connect the wiring plug.