Lamp Switch, Backup

Before replacing a backup lamp switch, be sure to check the condition of the lamp bulbs.

Since all backup lamp switches are operated by the transmission selector lever, replacement procedures differ according to mounting location of the selector lever and type of transmission used.

Automatic Transmission

Floor or Console-Mounted

Vehicles equipped with a floor or console-mounted automatic transmission still have a neutral start switch. On these vehicles, the backup lamp switch is an integral part of the neutral start switch. For adjustments and removal and installation, refer to Section 07-01A for vehicles equipped with A4LD transmissions or 07-01B for vehicles equipped with AOD transmissions.

Manual Transmission

Floor or Console-Mounted

4-Speed

Place the shift control lever in NEUTRAL and raise the vehicle on a hoist. Refer to Section 00-02. Disconnect the electrical connector from the switch. Unscrew switch from the transmission extension. Screw in new switch by hand and tighten to a maximum of 6.7 Nm (5 lb-ft). Connect electrical connector to the new switch.