Section 15-01: Radio and Tape Chassis
1993 Mustang Workshop Manual
REMOVAL AND INSTALLATION

Radio and/or Tape Player/CDR

The location of radio fuses is shown in Section 18-01.

Tool Required:

 

Removal

  1. Disconnect battery ground cable.
  1. Install Radio Removing Tool T87P-19061-A into radio face plate. Push tool in approximately 25.4mm (1 inch) to release retaining clips.

     CAUTION: Do not use excessive force when installing radio removing tool, as this will damage retaining clips, making radio removal difficult.

  1. Apply a light spreading force on tools and pull radio out of instrument panel.
  1. Disconnect the power, antenna and speaker wires.
 

Installation

  1. Connect wiring connectors and antenna cable to radio.
  1. Slide radio into instrument panel ensuring that radio rear bracket is engaged on upper support rail.
  1. Connect battery ground cable. Check radio and/or tape player for proper operation.