Section 13-09: Gauges, Warning Devices, Miscellaneous—Electronic
1993 Mustang Workshop Manual
REMOVAL AND INSTALLATION

Low Oil Level Sensor

 

Removal and Installation

  1. With engine off, drain at least 1.9 L (2 qt) of oil from engine.
  1. Disconnect electrical connection.
  1. Remove sensor with a 26mm (1 inch) socket or end wrench. discard old gasket.
  1. To install, reverse Removal procedure.

    NOTE: When replacing oil level sensor, use a new metal gasket with a rubber O-ring. Tighten sensor to 20-34 Nm (15-25 lb-ft).