Insert the blade of a small pocket screwdriver into the wire end loop
(crank arm end) of the control cable.
Grip the self-adjusting clip with pliers and slide it down the control wire
(away from the end loop) approximately 25.4mm (1 inch).
Install the cable assembly. Refer to Control Assembly and Temperature
Control Cable Removal and Installation.
Rapidly rotate the control knob to its fully warm position. This will
position the self-adjusting clip.
Check for proper control operation.
After Installation
Move the TEMP knob to the COOL position.
Hold the crank arm firmly in position, insert the blade of a small pocket
screwdriver into the wire loop and pull the cable wire end through the
self-adjusting clip until there is a space of approximately 25.4mm (1 inch)
between the clip and the wire end loop.
Rapidly move the control knob to its fully warm position to position the
self-adjusting clip.