Switch, Multi-Function

Removal

1. Disconnect battery ground cable.

2. Remove shroud retaining screws and remove upper and lower shrouds. Refer to Section 11-04.

3. Remove wiring connectors.

4. Remove two self-tapping screws retaining multi-function switch to steering column casting. Disengage switch from casting.

Installation

1. Align multi-function switch mounting holes with corresponding holes in the steering column casting. Install two self-tapping screws making sure to start the screws in the previously tapped holes. Tighten 2-3 Nm (18-26 lb-in).
   
   
   
   

2. Install electrical connector to full engagement.

3. Install upper and lower steering column trim shroud with the screws. Tighten to 0.6-1.13 Nm (6-10 lb-in).

4. Connect battery ground cable.

5. Check steering column and switch for proper operation.