Disconnect battery ground cable. Remove the steering column shroud by
removing the self-tapping screws.
Disconnect the ignition switch electrical connector.
Rotate the ignition key lock cylinder to the RUN position.
Remove the two screws retaining ignition switch.
Disengage the ignition switch from the actuator pin.
Installation
NOTE: A new replacement switch assembly will be set in the RUN position as
received.
Adjust the ignition switch by sliding the carrier to the switch RUN
position.
Check to ensure that the ignition key lock cylinder is in the RUN position.
The RUN position is achieved by rotating the key lock cylinder approximately 90
degrees from the LOCK position.
Install the ignition switch onto the actuator pin. It may be necessary to
move the switch slightly back and forth to align the switch mounting holes with
the column lock housing threaded holes.
Install retaining screws. TIghten to 5.6-7.9 Nm (50-69
lb-in).
Connect the electrical connector to the ignition switch.
Connect battery ground cable. Check ignition switch for proper function,
including START and ACC positions. Also, make certain that the column is locked
in the LOCK position.