Fuel Tanks

Fuel tanks do not require special service procedures and may be steam-cleaned and/or serviced using standard procedures. After steaming, allow to thoroughly air dry. The vapor separator assembly should be replaced. Replace fuel tank strap bolts.

 CAUTION: Remove the fuel pump prior to steaming the fuel tank. Care should be exercised not to deform the plastic reservoir inside the tank with excessively hot steam or direct contact with plastic surface.

An electric fuel pump is located in the fuel tank. The pump is attached to the fuel tank in the same manner as the sender unit. The fuel tank must be removed to service the fuel pump. Care should be taken during installation due to the hose and wire routing on the tank. Ensure all hoses and wires are routed properly. Check the fuel line connections for leaks.

 WARNING: FUEL SUPPLY LINES ON VEHICLES EQUIPPED WITH FUEL INJECTED ENGINES WILL REMAIN PRESSURIZED FOR LONG PERIODS OF TIME AFTER ENGINE SHUTDOWN. THE PRESSURE MUST BE RELIEVED BEFORE SERVICING THE FUEL SYSTEM. REFER TO FUEL SYSTEM PRESSURE RELIEF.