Fuel Filter

Removal

 WARNING: BECAUSE OF THE COMBUSTION CHARACTERISTICS OF GASOLINE, ALWAYS USE EXTREME CARE WHEN REMOVING AND INSTALLING ANY FUEL SYSTEM COMPONENT.

1. Depressurize the fuel system as outlined in Fuel System Pressure Relief.

2. Raise vehicle on hoist. Refer to Section 00-02.

3. Remove the push connect fittings at both ends of the filter as outlined. Install new retainer clips in each push connect fitting.

4. Remove fuel filter from bracket by loosening worm gear clamp. Note the direction of the flow arrow as installed in the bracket to ensure proper direction of fuel flow through replacement filter.

Installation

1. Install the fuel filter into the bracket, ensuring the proper direction of flow.

2. Tighten worm gear clamp to 1.7 to 2.8 Nm (15-25 lb-in).

3. Install the push connect fittings onto the filter ends as outlined.

4. Start engine and check for leaks.

5. Lower vehicle.