NOTE: If the governor body only is to be removed, skip Steps 2 and 3.
Remove the governor-to-output shaft retaining snap ring.
Using a soft-faced hammer, tap the governor assembly off the output shaft.
Remove the governor driveball.
Remove the governor-to-counterweight retaining screws. Lift the governor
from the counterweight.
Installation
Lubricate the governor valve parts with clean transmission fluid. Make
certain that the valve moves freely in the valve body bore.
Position the governor valve body on the counterweight with the cover facing
toward the front of the vehicle. Install the two retaining screws, and tighten
to 6-7 Nm (54-61 lb-in).
Position the governor drive ball into the pocket of the output shaft.
Align the keyway in the counterweight to the governor drive ball. Slide
governor assembly onto the output shaft. If necessary, gently tap governor into
position with a soft-faced hammer.
Reinstall the governor-to-output shaft retaining snap ring. Clean the
mounting surface on the transmission and on the extension housing. Position a
new gasket on the transmission.