CAUTION: Do not oil threads that require oil resistant or water resistant sealer.

When installing nuts or bolts, oil the threads with light weight engine oil.

Refer to Section 03-00 for Cleaning and Inspection procedures.

Cylinder Block

Before replacing a cylinder block, determine if it is serviceable. If so, make the necessary service. Refer to Section 03-00.

Disassembly

1. Completely disassemble the used engine, following the procedures in Removal and Installation.

2. Remember to ridge ream the cylinder bores before removing piston assemblies.

3. Remove the cylinder head locating dowels and the block drain plugs.

Assembly

1. Clean the gasket and seal surfaces of all serviceable parts and assemblies.

2. Position the new cylinder block in a work stand and install the cylinder head locating dowels and the block drain plugs.

3. Transfer all serviceable parts removed from the used cylinder block, following the procedures in Removal and Installation.

4. Check all assembly clearances and correct as necessary.