Remove the bolts attaching the fan shroud to the radiator.
Remove the fan, clutch and bolts from the water pump shaft. Remove the fan,
shroud, and drive belt.
Remove the crankshaft pulley from the vibration damper. Remove the damper
retaining screw and washer. Install the puller on the crankshaft vibration
damper and remove the vibration damper.
Place the Front Cover Seal Remover T70P-6B070-B onto the front cover plate
over the front seal. Tighten the two through bolts to force the seal puller
under the seal flange.
Alternately tighten the four puller bolts one-half turn at a time to pull
the oil seal from the front cover.
Installation
Coat a new front cover plate oil seal with Lubriplate or equivalent and
place it onto the Front Cover Seal Replacer T70P-6B070-A. Place the sleeve and
seal onto the end of the crankshaft and push it toward the engine until the
seal starts into the front cover.
Place the installation screw, washer and nut onto the end of the
crankshaft. Thread the screw into the crankshaft. Tighten the nut against the
washer and installation sleeve to force the seal into the front cover plate.
Remove the installation tool from the crankshaft.
Apply Lubriplate or equivalent to the oil seal rubbing surface of the
vibration damper inner hub to prevent damage to the seal. Apply Silicone Gasket
and Sealant F1AZ-19562-A (WSE-M4G320-A2) or equivalent, to keyway groove in
damper before installing on crankshaft.
Line up the crankshaft vibration damper keyway with the key on the
crankshaft. Install the vibration damper on the crankshaft. Install the cap
screw and washer. Tighten the screw to 95-122 Nm (70-90
lb-ft). Install the crankshaft pulley.
Position the fan shroud over the water pump pulley. Install the fan clutch.
Install the fan shroud retaining screws.
