Section 01-16: Wiper and Washer Systems
1993 Mustang Workshop Manual
REMOVAL AND INSTALLATION

Wiper Motor

When installing the drive arm to a new motor, follow the instructions included in the new motor kit.

 CAUTION: The internal permanent magnets used in the wiper motor are a ceramic (glass-like) material. Care must be exercised in handling the motor to avoid damaging the magnets. The motor must not be struck or tapped with a hammer or other object.

 

Removal

  1. Disconnect the battery and remove the RH wiper and blade assembly.
  1. Remove the cowl top grille retaining screws and grille.
  1. Remove clip.
  1. Disconnect the linkage drive arm from the motor crankpin.
  1. Disconnect the wiper motor's electrical connector and remove the wiper motor's three retaining screws. Pull the motor from the opening.
 

Installation

  1. Reverse Removal procedure. Tighten all motor retaining bolts to 7-9 Nm (60-80 lb-in).
  1. Before installing the arm and blade assembly to the pivot shaft, ensure the motor is in PARK and the blades are set to Dimension X as outlined under Adjustments.