Door Latch Striker

Tools Required:

• Torx® Drive Bit Set D79P-2100-T

The striker pin can be adjusted laterally and vertically as well as fore-and-aft. The latch striker should not be adjusted to correct door sag.

The latch striker should be shimmed to get the clearance shown between the striker and latch. To check this clearance, clean the latch jaws and the striker area. Apply a thin layer of dark grease, such as Premium Long-Life Grease XG-1-C (ESA-M1C75-B) or equivalent to the striker. As the door is opened and closed, a measurable pattern will result on the latch striker. Use a maximum of two shims under the striker.

Move the striker assembly in or out to provide a flush fit at the door and pillar or quarter panel. Use Torx® Drive Bit Set D79P-2100-T or equivalent to loosen and tighten the latch striker. Tighten to 35-45 Nm (26-33 lb-ft).