Door Lock/Window Control Switch

NOTE: Due to the conversion from single 90 degree rod to double 90 degree rod, it may be necessary to remove more parts than the instructions indicate. This action will allow more maneuverability of the rod and ease the removal process.

Removal and Installation

1. Remove switch housing retaining screw and rotate housing up and out of armrest.

2. Remove two connector retaining screws from bottom of switch housing.

3. Switch is held in place by electrical contact pins. To remove switch, carefully pry switch from connector with small screwdriver.

4. To install, reverse Removal procedure.

   NOTE: The switch is keyed to the connector and can only be installed one way.