Quarter Window, Stationary

Removal and installation of the stationary quarter window is typical on all vehicles.

Removal

1. Remove interior garnish mouldings and outside drip rail mouldings. Refer to Section 01-05.

2. Remove nuts attaching quarter window assembly to quarter panel. Remove window assembly from opening.

3. Remove all butyl from sheet metal flange and from window assembly if window is to be reused.

Installation

1. Apply foam core butyl service tape to sealing surface on backside of window assembly.

   NOTE: Seal tape is not applied to the rear edge of the window assembly, but on seal surface through center of window.

2. Position window assembly to opening and install retaining nuts. Tighten to 1-2 Nm (9-17 lb-in).

3. Slide drip rail moulding onto tab at front of quarter window assembly and install to roof.

4. Install interior garnish mouldings. Refer to Section 01-05.