Disconnect battery ground cable and air bag backup power supply.
Remove two trim shroud halves by removing retaining screws.
Disconnect the ignition switch electrical connector.
Turn ignition key lock cylinder to the RUN position.
Remove two screws that connect the switch to lock cylinder housing.
Disengage the ignition switch from the actuator pin.
Installation
NOTE: A new replacement switch assembly will be set in the RUN position.
Adjust the ignition switch by sliding the carrier to the RUN position.
Make sure that the ignition key lock cylinder is in approximately the RUN
position. The RUN position is achieved by rotating the key lock cylinder
approximately 90 degrees from the LOCK position.
Install the ignition switch onto the actuator pin. It may be necessary to
move the switch slightly back and forth to align the switch mounting holes with
the column lock housing threaded holes.
Install two retaining screws. Tighten to 5.6-7.9 Nm (50-60
lb-in).
Connect electrical connector to ignition switch.
Connect battery ground cable to battery terminal. Check ignition switch for
proper function including START and ACCESSORY positions. Also, ensure the
column is locked in the LOCK position.
Install the steering column trim shrouds.
Connect air bag backup power supply and battery ground cable.