Section 11-02: Steering System, Power
1993 Mustang Workshop Manual
REMOVAL AND INSTALLATION

Pulley

Tools Required:

 

Removal

  1. Drain as much fluid as possible from the pump through the reservoir neck.
  1. Install Steering Pump Pulley Remover T69L-10300-B on the pulley hub, and place the tool and pump in a vise by gripping the small hex-head of the tool.

     CAUTION: Do not apply in and out pressure on the pump shaft. Pressure will damage the internal thrust areas.

  1. Hold the pump, and rotate the tool nut counterclockwise to remove the pulley.



 

Installation

  1. Place the pulley on the pump shaft, and install Steering Pump Pulley Replacer T65P-3A733-C. The small diameter threads on the tool should be fully engaged in the pump shaft.

     CAUTION: Do not apply in and out pressure on the shaft. Pressure will damage the internal thrust areas.

  1. Hold the pump, and rotate the tool nut clockwise to install the pulley on the shaft. The pulley face must be flush within 0.25mm (0.010 inch) of the end of the pump shaft.
  1. Remove the tool.