Starter/Clutch Interlock Switch

Removal

1. Disconnect wiring connector.

2. Remove retaining pin from clutch pedal.

3. Remove switch bracket retaining screw.

4. Lift switch and bracket assembly upward to disengage tab from pedal support.

5. Move switch outward to disengage actuating rod eyelet from clutch pedal pin. Remove switch from vehicle.

Installation

NOTE: Always install the switch with the self-adjusting clip about 25.4mm (1 inch) from the end of the rod. The clutch pedal must be fully up (clutch engaged), otherwise the switch may be misadjusted.

1. Place eyelet end of rod onto pivot pin.

2. Swing switch assembly around, engage tab in top of pedal support, and line up hole in mounting boss with hole in bracket.

3. Install retaining screw.

4. Install retaining pin on clutch pedal.

5. Connect wiring connector.