Remove LH lower instrument panel trim and steering column lower shroud.
Remove interlock cable retaining screw and disconnect cable from shift
lever cam.
Remove steering column retaining nuts and lower column to floor.
Remove cable retaining clip. Disconnect electrical connector at solenoid.
Remove cable retaining screw from steering column.
Guide interlock cable out from under console brackets.
To install, reverse Steps 1 through 8. Tighten steering column retaining
nuts to 34-46 Nm (25-34 lb-ft).
Tighten cable retaining screw at steering column to 3.1-4.3 Nm
(27-38 lb-in) and at shifter to 1.6-2.2 Nm
(14-19 lb-in).
Test for proper operation. The ignition key should only be removable with
the shift lever in PARK. The shifter should be locked in PARK with the key
removed. The shifter should also be locked in PARK with the ignition key in the
ON position, and be released when the service brakes are applied.