Brake Master Cylinder Reservoir

Removal

NOTE: Whenever the small (secondary) reservoir port is removed from the master cylinder, the reservoir assembly must be replaced and new grommets must be installed.

1. Disconnect fluid level indicator switch.

2. Remove cap from reservoir.

3. Using needlenose pliers, remove float from reservoir.

4. Remove brake fluid from reservoir.

5. Remove primary reservoir port from master cylinder by prying upward with rod or long screwdriver, as shown in the previous illustration.

6. Remove secondary reservoir port in same manner and discard complete reservoir assembly.

7. Remove grommets from master cylinder.

Installation

1. Wet new grommet in clean brake fluid and press into master cylinder.

2. Wet reservoir ports in clean brake fluid and press new reservoir assembly into grommets.

3. Connect fluid level indicator switch.